Bunna3 codename Zebra3
A3 motor a35 Conrod. Za50 points to cdi. Flywheel.
Have idm "blaster" cdi box
I have an oem idm flywheel but I would need to drill arch slits for the points case.
A3 black and silver classic casehalves pin type. A3 case covers classic black tranny case was an early no logobadge case. Add the anniversary bunny badge.
45mm Airsal kit. Oem Tomos head modded for 70cc kit. Squish is tight.Blue printed balanced crank clutch bell a3. a3 shoey goodness, new bearings, seals, needlecages and low mile countershaft.
A3 main pedalshaft super short beartrap pedals. Techno estroil sidebleed.
20mm intake restricted to my modded oem sha 15.14 capacity. But after break in, I have a amal 18mm. I have to jet and dial in, but i know the kit and pipe work better than well together.
26x26 gears my 96 Targa frame aka the cereal killer
The dreaded one's old bike.
My bud Julio used to call him that. vegetarian but creepy none the less...
I have the Colibre frame so after running the Targa for shake down transfer to Colibre frame and use the H erokit I have had forever. Or slap an a35 on it and hero the e50 motor I have cobbled on. And figure how to bativise it.
1rst world moped problems...