Chapter 14 - Wiring, Part 2
Next up, getting the sleeving and connectors in place. Several more hours here, since it involved making final decisions on where parts would live and thus length of wire runs. I can crimp and assembly those Weatherpack guys real fast now!
Here it is after mostly finishing the rear end of the harness. Headlight end obviously needs a lot more work:
And pretty much all done here. I may add one more disconnect for the headlight; the H4 connector lives inside the headlight bucket, so had to pop out the pins to feed it through the hole. The good news is, it took me less than a minute to disconnect everything and pull the entire harness out of the bike for this photo:
Hey, so far everything works!