I'm done with this stuff for now. Bringing it home to wash in the sink and prepare for bottom end assembly.
The blue shmoo is pretty great for marking gasket paper. I just slather it on the surface and press it against the paper before it gets a chance to dry. I did it on bubble wrap and i think that helped make the edge lines sharp. Pretty neat.
I have to figure out my base spacing and cut some gaskets to figure all that shit out. I have some dremel beer marks on the spacer that i might just fill will some jb weld or whatever. Might just put some non-hardening sealant in there. Flying by the seat of my pants