Motor mount bushing removal
$2.64 worth of hardware at mom & pops hardware store.
-Long bolt (high grade) -Washers(4) the same size as the bushing -Nut -PVC fitting so the bushing would fit inside, but still rest against the hole where it goes.
Later that night:
I tried making my own puller with hardware listed above, but those little bastards destroyed my bolt threads. I recommend getting all the rubber out of the bushing and using a dremel to cut the metal in half. Took 5 minutes to take both out with this method. You can't reuse them, but that's why you bought new ones right? The little one did actually work using a socket, bolt, nut, and washers.
|This article is a stub.|
|You can help the Moped Wiki by expanding it.|