Difference between revisions of "Tomos Oil Injection Removal"

From Moped Wiki
Jump to: navigation, search
m (link to oil injector)
m (add category)
Line 6: Line 6:
 
[[Category: Modification Tutorials]]
 
[[Category: Modification Tutorials]]
 
[[Category:Tomos|Oil Injection Removal]]
 
[[Category:Tomos|Oil Injection Removal]]
 +
[[Category: Tomos Repair Tutorials]]

Revision as of 23:06, 24 August 2009

If you choose not to trust your Tomos oil injector system, here is a brief how-to on removing it. Just remember that you'll have to use premix from now on.

Drain and remove the oil tank, (just cut the oil line off) remove the little round cover on the left side of the engine that attaches with one screw, the pump is behind that cover. remove the 2 screws and remove the pump. Look for where the oil line attaches to the carburetor, you will either need to pull it off and cap off the fitting with a vacuum cap, or cut off the line close to the carb, leaving enough to put a plug in. There are 2 lines, one from the oil tank to the pump, and one from the pump to the carb. Removing those usually requires removing the flywheel/magneto cover, which is the part that the pump attached to. It’s not difficult, and there is no oil behind it. That’s the entire system, the tank, lines, and pump. Remember that before you can start it, you have to drain all the gas out of the tank and carb, and fill it with premix, to avoid starting it on straight gas.